This Hydraulic Motor is an SAE C-face, 4 bolt mount used for the PM2000 and the PM3000 vacuum pumps. 72gpm/2500 psi required.

This Hydraulic Motor is a SAE-B face, 4 bolt motor used for the PM60A and the PM70T vacuum pumps. 22 gpm/2500 psi required.

This Hydraulic Motor is a SAE-B face, 4 bolt mounts used for the PM70A vacuum pumps. 29gpm/2500 psi required.

This Hydraulic Motor is an SAE B-face, 4 bolt mount used for the PM80A, PM80T, AC5T, and the PM80W vacuum pumps. 36gpm/2500 psi required.

In-Line Circuit Breaker

The Moro Kaiser KWP 2000i Liquid Ring Pump is a low weight liquid ring vacuum pump for suction and pneumatic conveyance of wet and dry material. This pump features 1177 CFM and 14.5 PSI.

A water ring is built up inside the KWP housing by the centrifugal force generated by an offset impeller. Changes in volume cause air to be drawn into the impeller cells and compressed. This design ensures a low level of sensitivity to dirt particles. The non-contacting impeller ensures smooth running and a long service life. Our KWP does not produce any contamination caused by lubricants or oil in the air discharged by the pump.

The light-weight construction of this equipment increases the vehicle’s useful load. Hosting an integrated intercooling system ensures a consistently low temperature for the service water. Even if this equipment is operating during high exterior temperatures, continuous operation is possible.